سلام مهندس من 4 فایلی اموزشی شما رو خوندم منتها هنوز تو مدل کردن مساله ام مشکل دارم
یه مساله بصورت زیر رو میخوام مدل کنم
the cyclic loading of a thick cylinder made of CS1020 carbon steel subjected to internal pressure using the
Prager kinematic hardening model. The data are: modulus of
elasticity E=173.2 GPa, yield stress s=241 MPa, Poisson’s
ratio, nZ0.3, thermal expansion coef
fi
cient alpha=10.8*10E-6
ratio of the outside to inside radius b/a=1.5, m=2631 MPa, and
n=0.35. The inside pressure varies between 0 and 240 MPa. The
yield pressure, where the inside surface yields, is P=77 MPa.
The average pressure cycle is P=120 MPa. Since the load is of
mechanical type and the mean load is not zero, the case is load
controlled cyclic loading. The
fi
gure shows the stress at the inside controlled cyclic loading
منتها چنتا مشکل جدی دارم
1- اینکه آیا نیازه تمام حجم مخزن رو مدل کنم یا یک چهارمش کافیه؟(بدلیل تقارن)
2- کربن cs1020 (همچین جنسی رو پیدا نمیکنم ) توی material ها!
3-
Prager kinematic hardening model. موجود نیست نهایتا تونستم مدل chaboche رو پیدا کنم.
4-برای رسم نمودار تنش کرنش(حلقه های هیسترزیس) نیاز به داده هاای اولیه دارم طبق کتاب جاهد مطلق برای رسم این نمودار نیاز به جدولی مربوط به مقادیر تنش و کرنش دارم که هیچ داده ای تو صورت سوال نیست. آیا این داده ها رو باید از معادله ای مثل ludwick خودم بدست بیارم؟؟
بازم مممنونم از وقتی که میذارید.